This is a simple pulse generator to use for testing purposes. It uses the LM324 operational amplifier, and the frequency can be controlled with a potentiometer. The LM324 chip is not that fast, so the frequency will be limited.

Project photograph or diagram

I used LTSpice for schematics and simulation: Project photograph or diagram The frequency range for this with C1=33nF is about 10 Hz to 6kHz. If you replace the capacitor with a 10nF, it will go up to about 11kHz. But the waveform will suffer, as it will be more like a triangle wave. It will produce an output of 5V peak. At 160 Hz it should look like this: Project photograph or diagram I created a PCB in FreePCB: Project photograph or diagram For 1200 dpi images see the links at the bottom of this article.Project photograph or diagram Project photograph or diagram Project photograph or diagram Part list:
R1 - 10 kOhm
R2 - 100 kOhm
R3 - 100 kOhm
R4 - 10 kOhm
R5 - 12 kOhm
R6 - 10 kOhm
C1 - 33 nF
POT1 - 1 MOhm
U1 - LM324
P1 - 3 x CMM 2 pol 5 mm spacing
Files: http://www.lamja.com/blogfiles/PulseGenerator.asc http://www.lamja.com/blogfiles/PulseGeneratorBottomCopper.png http://www.lamja.com/blogfiles/PulseGeneratorBottomCopperMirror.png http://www.lamja.com/blogfiles/PulseGeneratorTopSilk.png http://www.lamja.com/blogfiles/PulseGeneratorTopSilkMirrored.png